In other words, all IP traffic passes through the serial line. That you use different IP addresses for PPP and Ethernet.Īs shown above, if each system has only one IPĪddress, when an ifnet interface is set up between target_PPP and host_PPP, all traffic to host_PPP is routed through It is strongly recommended for this release Figure 4-2 IP Traffic-Both Ethernet and PPP In order to make sure the Ethernet interface can still be used for IP traffic, use different IP addresses forĮthernet and IP. The process therefore remains the same whether you Services altogether using the pppstop command. You may close it using the pppclose command.

To enable a connection to a specific serial line. PPP as implemented in ChorusOS 4.0 handles IP traffic differently than previous releases. To the Ethernet IP address, and that hostname_PPP refers to the hostname corresponding to the PPP address. As you read, be aware that hostname refers to the Ethernet hostname corresponding This document differentiates between Ethernet Internet addressesĪnd PPP addresses. Systems often have two IP addresses: one for Some platforms, a unique serial line is used both for the consoleĪt boot time, the serial line connector must be connected to the host tip line. It assumes the serial line or modem is already physically connected. This section explains how to configure Point-to-Point Protocol (PPP) with the ChorusOS 4.0 product standard interface and drivers.

Ip over serial ppp